Handheld Die-Cut Sheet Stripping FAQs
Got a question?
Hopefully our frequently asked questions below can help answer yours too.
Get in touch
If we haven’t answered your question, please feel free to get in touch via our Contact page.
Does the stripper work on all types of carton board?
Yes. It will also handle solid and corrugated fibre board.
Will I have to modify my dies?
This depends on how much stripping rule is already on the die. A waste strip of no more than 45cm is ideal. The smaller the section, the easier it is to remove.
Will the stripper handle corrugated and laminated board?
Yes. Answer above applies. Also on how even a stack comes off the die-cutter. An uneven stack will not provide the support from below to allow the stripper to work efficiently removing the strip above.
Will the stripper handle large waste sections?
Yes. Provided that the cut is good and the notching is not too heavy, large sections pose no problem.
Can I use the stripper on work coming off a hand platen?
This depends on a good even stack. It would be necessary to shutter up against a guide and also the ability to put stripping rule on the job in hand.
How much time will I save using the stripper?
A time saving of 85% is achievable against performing the task manually.
What is the minimum waste strip depth the Cartostrip will handle?
Toggle Content goes here
